![]() ![]() Thanks for your answer, now i'm not worry about the power. Screenshot 3: dual monitor in Windows drawing 76w on idle. Screenshot 2: system of but the NAS, r outer & switch are on the same socket drawing 50w Screenshot 1 : Dual monitor setup in macOS consumes 79w on idle. ![]() Temp of the card is around 48 to 50 on idle and therefore the vents always turn on & off. DirectX 12 (120) OpenGL 4.6 OpenCL 2.1 Vulkan 1.3 Shader Model 6.7. I do think they are not correct, started a bit of troubleshooting and searching on the net because I got a similiar setup & when having two monitors connected the RX 580's memory clock is constantly at 2Ghz. Power Connectors 1x 8-pin Board Number C940, D009-04. In Windows HWmonitior & Radeon tool says the card takes about 32w in idle. At first I thought just like you that there might be problem, but compared to Windows it takes the same power from the wall. IStat says that my RX 580 is taking about 90 to 100w constantly. ![]() Screenshot 2: system of but the NAS, router & switch are on the same socket drawing 50w My setup: Z390 Aorus Master, 9700k, RX 580 Sapphire Nitro Pulse, Mojave & Clover. I just measured at the wall socket moments ago: With only one monitor connected temps are 10° lower. Temp of the card is around 48 to 50 on idle and therefore the vents always turn on & off. I do think they are not correct, started a bit of troubleshooting and searching on the net because I got a similiar setup & when having two monitors connected the RX 580's memory clock is constantly at 2Ghz. So if you have any ideas, please let me know. Inject "fb name", got from clover, dont know how to apply it on opencore GPU Patching with DeviceProperties in opencore, like this article( Converting a clover fakeID to OpenCore), but i dont know how to get FakeID I have the following three methods I haven’t tried and also I don’t know how to start (at least now) This is my first time using hackintosh and opencore, and I have tried to solve this problem for a whole day.
0 Comments
Leave a Reply. |